Multiscale modelling of biomolecular corona formation on metallic surfaces

• Parinaz Mosaddeghi Amini,
• Ian Rouse,
• Julia Subbotina and
• Vladimir Lobaskin

Beilstein J. Nanotechnol. 2024, 15, 215–229, doi:10.3762/bjnano.15.21

• milk as compared with other proteins. Figure 8 shows the mass abundance of each protein on both aluminum (Al(100), Al(110), and Al(111)) and iron (Fe(100), Fe(110), and Fe(111)) surfaces. We can also observe that AS1C, BLAC, and ALAC display significantly enhanced presence on Fe surfaces in contrast to

Sputtering onto liquids: a critical review

• Anastasiya Sergievskaya,
• Adrien Chauvin and
• Stephanos Konstantinidis

Beilstein J. Nanotechnol. 2022, 13, 10–53, doi:10.3762/bjnano.13.2

Topographic signatures and manipulations of Fe atoms, CO molecules and NaCl islands on superconducting Pb(111)

• Carl Drechsel,
• Philipp D’Astolfo,
• Jung-Ching Liu,
• Thilo Glatzel,
• Rémy Pawlak and
• Ernst Meyer

Beilstein J. Nanotechnol. 2022, 13, 1–9, doi:10.3762/bjnano.13.1

• with functionalized tips. We report on the topographic signatures observed by scanning tunneling microscopy (STM) of carbon monoxide (CO) molecules, iron (Fe) atoms and sodium chloride (NaCl) islands deposited on superconducting Pb(111). For the CO adsorption a comparison with the Pb(110) substrate is

Proximity effect in [Nb(1.5 nm)/Fe(x)]₁₀/Nb(50 nm) superconductor/ferromagnet heterostructures

• Yury Khaydukov,
• Sabine Pütter,
• Laura Guasco,
• Roman Morari,
• Gideok Kim,
• Thomas Keller,
• Anatolie Sidorenko and
• Bernhard Keimer

Beilstein J. Nanotechnol. 2020, 11, 1254–1263, doi:10.3762/bjnano.11.109

• the thickness of the Fe layer to x = 4 nm the intermediate phase disappears. We attribute the intermediate state to proximity induced non-homogeneous superconductivity in the structure. Keywords: ferromagnet; iron (Fe); mixed state; neutron reflectometry; niobium (Nb); proximity effects

Uniform Fe₃O₄/Gd₂O₃-DHCA nanocubes for dual-mode magnetic resonance imaging

• Miao Qin,
• Yueyou Peng,
• Mengjie Xu,
• Hui Yan,
• Yizhu Cheng,
• Xiumei Zhang,
• Di Huang,
• Weiyi Chen and
• Yanfeng Meng

Beilstein J. Nanotechnol. 2020, 11, 1000–1009, doi:10.3762/bjnano.11.84

• distributed Fe3O4/Gd2O3 nanocubes for T1–T2 dual-mode MRI contrast agents were successfully designed and synthesized. In order to increase hydrophilicity and biocompatibility, the nanocubes were coated with nontoxic 3,4-dihydroxyhydrocinnamic acid (DHCA). The results show that iron (Fe) and gadolinium (Gd

Surface characterization of nanoparticles using near-field light scattering

• Eunsoo Yoo,
• Yizhong Liu,
• Chukwuazam A. Nwasike,
• Sebastian R. Freeman,
• Brian C. DiPaolo,
• Bernardo Cordovez and
• Amber L. Doiron

Beilstein J. Nanotechnol. 2018, 9, 1228–1238, doi:10.3762/bjnano.9.114

• were not obtainable because of the continuous degradation of the polymer coating under the electron beam exposure. The energy dispersive X-ray spectroscopy (EDS) spectrum of the uncoated SPIOs (Figure 3C) showed peaks corresponding to iron (Fe) and oxygen (O), as expected, while the TEM grid and Si (Li

Anchoring Fe₃O₄ nanoparticles in a reduced graphene oxide aerogel matrix via polydopamine coating

• Błażej Scheibe,
• Radosław Mrówczyński,
• Natalia Michalak,
• Karol Załęski,
• Michał Matczak,
• Mateusz Kempiński,
• Zuzanna Pietralik,
• Mikołaj Lewandowski,
• Stefan Jurga and
• Feliks Stobiecki

Beilstein J. Nanotechnol. 2018, 9, 591–601, doi:10.3762/bjnano.9.55

• ammonia in Fe3O4-containing samples made the identification of the PDA-related nitrogen peaks problematic. The analysis of the iron Fe 2p region indicated the presence of Fe3O4, as the fitted components – corresponding to Fe2+, Fe3+ and satellites – were positioned at the characteristic binding energy

Single-step process to improve the mechanical properties of carbon nanotube yarn

• Maria Cecilia Evora,
• Xinyi Lu,
• Nitilaksha Hiremath,
• Nam-Goo Kang,
• Kunlun Hong,
• Roberto Uribe,
• Gajanan Bhat and
• Jimmy Mays

Beilstein J. Nanotechnol. 2018, 9, 545–554, doi:10.3762/bjnano.9.52

• intensity for the C–O peak (see Figure 1). As also illustrated in Table 1, some traces of contaminant elements (sulfur (S), iron (Fe) and aluminum (Al)) were observed in XPS spectra of all samples, which can be attributed to traces of the inhibitor metal salt, FeSO4 and other contaminants. The samples

Growth, structure and stability of sputter-deposited MoS₂ thin films

• Reinhard Kaindl,
• Bernhard C. Bayer,
• Roland Resel,
• Thomas Müller,
• Viera Skakalova,
• Gerlinde Habler,
• Rainer Abart,
• Alexey S. Cherevan,
• Dominik Eder,
• Maxime Blatter,
• Fabian Fischer,
• Jannik C. Meyer,
• Dmitry K. Polyushkin and
• Wolfgang Waldhauser

Beilstein J. Nanotechnol. 2017, 8, 1115–1126, doi:10.3762/bjnano.8.113

• was previously reported [29][49]. Given that the films presented in this study have been sputtered from a MoS2 target with a purity of 99.5 wt %, which contains 0.03 wt % SiO2, 0.02 wt % MoO3, 0.01 wt % copper oxide (CuO), 0.019 wt % iron (Fe) and up to 0.20 wt % not specified compounds, in a metallic

Selective detection of Mg²⁺ ions via enhanced fluorescence emission using Au–DNA nanocomposites

• Tanushree Basu,
• Khyati Rana,
• Niranjan Das and
• Bonamali Pal

Beilstein J. Nanotechnol. 2017, 8, 762–771, doi:10.3762/bjnano.8.79

• detect the presence of metal ions in a solution. Calcium (Ca), iron (Fe) and magnesium (Mg) were chosen because of their high abundance and importance in nature. Au–DNA NCs are a convenient and time-effective approach to metal detection. As can be observed in Figure 9a, the detection of Ca2+ did not

Microscopic characterization of Fe nanoparticles formed on SrTiO₃(001) and SrTiO₃(110) surfaces

• Miyoko Tanaka

Beilstein J. Nanotechnol. 2016, 7, 817–824, doi:10.3762/bjnano.7.73

• . From profile-view TEM images, approximate values of the adhesion energy of the nanoparticles for both shapes are obtained. Keywords: epitaxial orientation relationship; iron (Fe); nanoparticles; morphology; scanning electron microscopy (SEM); strontium titanate (SrTiO3); transmission electron

Novel ZnO:Ag nanocomposites induce significant oxidative stress in human fibroblast malignant melanoma (Ht144) cells

• Syeda Arooj,
• Samina Nazir,
• Akhtar Nadhman,
• Nafees Ahmad,
• Bakhtiar Muhammad,
• Ishaq Ahmad,
• Kehkashan Mazhar and
• Rashda Abbasi

Beilstein J. Nanotechnol. 2015, 6, 570–582, doi:10.3762/bjnano.6.59

• photocatalytic decomposition process is slow and needs to be improved [24]. Therefore, it is interesting to enhance their photocatalytic ability and anticancer activity by forming nanocomposites with other materials, including metal ions such as silver (Ag) or iron (Fe) ions [25]. The ZnO:Ag nanocomposites

Effect of large mechanical stress on the magnetic properties of embedded Fe nanoparticles

• Srinivasa Saranu,
• Sören Selve,
• Ute Kaiser,
• Luyang Han,
• Ulf Wiedwald,
• Paul Ziemann and
• Ulrich Herr

Beilstein J. Nanotechnol. 2011, 2, 268–275, doi:10.3762/bjnano.2.31

• explained by an additional magneto-elastic anisotropy which leads to an “easy plane” rather than an “easy axis”. The results may be useful for the optimization of the magnetic properties of future magnetic data storage media. Experimental Iron (Fe) nanoparticles were generated using a custom-built plasma

Magnetic nanoparticles for biomedical NMR-based diagnostics

• Huilin Shao,
• Tae-Jong Yoon,
• Monty Liong,
• Ralph Weissleder and
• Hakho Lee

Beilstein J. Nanotechnol. 2010, 1, 142–154, doi:10.3762/bjnano.1.17

• The synthesis of elemental iron-based nanoparticles (i.e., with elemental iron rather than iron oxides) and their stable dispersion in aqueous media, has remained one of the most attractive goals in magnetic nanomaterial engineering. Elemental iron (Fe) has a higher magnetization than that of metal

• ferrite nanoparticles (MnFe2O4). These nanoparticles have narrow size distribution and high crystallinity, and were synthesized by a seed-growth method to produce 10, 12, 16, and 22 nm nanoparticles. (b) TEM image of elemental iron (Fe) core/ferrite shell magnetic nanoparticles (CB; cannonballs). These